Cisco 300-510 Practice Verified Answers - Pass Your Exams For Sure! [2022]
Valid Way To Pass CCNP Service Provider's 300-510 Exam
Introduction to Implementing Cisco Service Provider Advanced Routing Solutions (300-510 SPRI) Exam
It is a 90-minute test affiliated with the CCNP Service Provider and Cisco Accredited Professional-Service Provider VPN Services Implementation certifications. Implementing Cisco Service Provider Advanced Routing Solutions (300-510 SPRI) exam tests the candidate's knowledge of integrating VPN services, including Layer 2, Layer 3, and IPv6, from the service provider. Different types of 310-510 SPRI practice test helps the students to prepare for the exam.
NEW QUESTION 54
An engineer is troubleshooting end-to-end customer traffic across an MPLS VPN service provider network.
Which tasks should the engineer use to solve the routing issues? Drag and drop the table types from the left onto the most useful troubleshooting tasks/router types on the right. (Not all options are used.)
Answer:
Explanation:
NEW QUESTION 55
Refer to the exhibit.
P1 and PE3 Cisco IOS XR routers are directly connected and have this configuration applied. The BGP session is not coming up. Assume that there is no IP reachability problem and both routers can open tcp port 179 to each other. Which two actions fix the issue? (Choose two.)
- A. Change MD5 to SHA-1
- B. Change MD5 to HMAC-MD5
- C. Change MD5 to HMAC-SHA1-12
- D. Remove the send and accept lifetime under key 1
- E. Change MD5 to HMAC-ESP
Answer: B,C
Explanation:
Reference:
https://www.cisco.com/c/en/us/td/docs/routers/crs/software/crs_r4-0/security/configuration/guide/ sc40crsbook_chapter5.html
NEW QUESTION 56
Refer to the exhibit. How are packets directed through the data plane when SRv6 is implemented?
- A. The packet is encapsulated with a header and trailer encoding the ordered list of segments
- B. A stack of labels represents an ordered list of segments
- C. The MPLS data plane is used to push labels onto IGP routes
- D. An ordered list of segments is encoded in a routing extension header
Answer: D
Explanation:
Explanation/Reference: https://www.ciscolive.com/c/dam/r/ciscolive/emea/docs/2019/pdf/BRKIPM-2249.pdf
NEW QUESTION 57
In a PIM-SM environment, which mechanism determines the traffic that a receiver receives?
- A. The receiver explicitly requests traffic from a single source, which responds by forwarding all traffic.
- B. The RP on the shared tree floods traffic out of all PIM configured interfaces.
- C. The receiver explicitly requests traffic from each desired source, which responds by sending all traffic.
- D. The receiver explicitly requests its desired traffic from the RP on the shared tree.
Answer: C
NEW QUESTION 58
Refer to the exhibit.
A network operator wants to expand the segment routing global block in upcoming maintenance. The operator must ensure that the changes to the segment routing global block have no adverse impacts on the prefix-sid associated with the loopback0 interface used within the OSPF domain.
Which command can the operator use to enforce R2 to have a strict prefix-sid assignment to loopback0?
- A. Option C
- B. Option D
- C. Option B
- D. Option A
Answer: A
NEW QUESTION 59
What is used by SR-TE to steer traffic through the network?
- A. shortest path calculated by IGP
- B. explicit maps
- C. dynamic rules
- D. path policy
Answer: D
NEW QUESTION 60
A network engineer is troubleshooting OSPF multiare A.
Which Cisco IOS XR feature should the engineer use in order to streamline OSPF issue?
- A. DR support for topology management
- B. hierarchical CLI
- C. show ip ospf topology command
- D. routing process enabled by default on all interfaces
Answer: B
Explanation:
Reference:
https://www.cisco.com/c/en/us/td/docs/routers/xr12000/software/xr12k_r4-0/routing/configuration/ guide/rc40xr12k_chapter4.html#con_1059437
NEW QUESTION 61 
Refer to the exhibit. R1 is directly connected to R2 and R3. R1 is in BGP AS 123, R2 is in BGP AS 2, and R3 is in BGP AS 3. Assume that there is no connectivity issue between R1, R2 and R1, R3. Which result between BGP peers R1, R2 and R1, R3 is true?
- A. The BGP session comes up between R1 and R2, but not between R1 and R3.
- B. The BGP session comes up between R1 and R2 and between R1 and R3.
- C. The BGP session does not come up between R1 and R2 and between R1 and R3.
- D. The BGP session comes up between R1 and R3, but not between R1 and R2.
Answer: B
NEW QUESTION 62
Refer to the exhibit.
Which statement about this configuration is true?
- A. Router 1 sends and receives multiple best paths from neighbor 192.168.1.1
- B. Router 1 sends up to two paths to neighbor 192.168.1.1 for all routes
- C. Router 1 receives up to two paths from neighbor 192.168.1.1 for all routes in the same AS
- D. Router 1 receives only the best path from neighbor 192.168.1.1
Answer: A
NEW QUESTION 63
Refer to the exhibit.
Router 1 has attempted to establish a Cisco MPLS TE tunnel to router 2, but the tunnel has failed. Which statement about this configuration is true?
- A. Router 2 must have a tunnel interface created with router 1 as the destination
- B. Router 1 and router 2 must define the RSVP bandwidth reserved on the physical interfaces
- C. Router 1 must have Cisco MPLS TE enabled on interface gigabitethernet0/1
- D. Router 1 must define an explicit path to router 2
Answer: C
NEW QUESTION 64
Refer to the exhibit.
A network operator is getting the route for 10.11.11 0/24 from two upstream providers on
#XR3. The network operator must configure #XR3 to force the 10.11.11.0/24 prefix to route via next hop of
10.0.0.9 as primary when available. Which of these can the operator use the routing policy language for, to enforce this traffic forwarding path?
- A. lower local preference on the prefix coming from 192.168.0.2
- B. weight of 100 on the prefix coming from 192.168.0.1
- C. weight of 0 on the prefix coming from 192.168.0.2
- D. higher local preference on the prefix coming from 192.168.0.1
Answer: C
NEW QUESTION 65
Refer to the exhibit.
Why is neighbor 10.1.5.5 stuck in "2WAY" state?
- A. OSPF parameters (Area ID or hello interval) are mismatched between R2 and 10.1.5.5
- B. OSPF authentication has failed between R2 and 10.1.5.5
- C. Router ID 10.1.5.5 is not reachable from R2
- D. It is an expected behavior when OSPF network type is broadcast
Answer: D
NEW QUESTION 66
Refer to the exhibit.
After you applied these configurations to routers R1 and R2, the two devices could not form a neighbor relationship. Which reason for the problem is the most likely?
- A. The two routers cannot authenticate with one another.
- B. The two routers have the same area ID.
- C. The two routers have the same network ID.
- D. The two routers have different IS-types.
Answer: A
NEW QUESTION 67
Refer to the exhibit.
How are packets directed through the data plane when SRv6 is implemented?
- A. The packet is encapsulated with a header and trailer encoding the ordered list of segments
- B. A stack of labels represents an ordered list of segments
- C. The MPLS data plane is used to push labels onto IGP routes
- D. An ordered list of segments is encoded in a routing extension header
Answer: D
NEW QUESTION 68 
Refer to the exhibit. A network operator must stop 10.33.33.33/32 from being redistributed into Level 1 router XR1. Which configuration meets this need?
- A.
- B.
- C.
- D.
Answer: C
Explanation:
Explanation/Reference:
NEW QUESTION 69
Refer to the exhibit.
A network operator is troubleshooting TE tunnels and discovers that the soft preemption is not working as desired. Where should the soft preemption be applied to solve the issue?
- A. explicitly for tunnel-te 1 under the Cisco MPLS TE configuration mode after the timeout setting
- B. Under the interface Loopback0 necessary for this deployment type.
- C. under the tunnel-te1 interface on PE1
- D. on the tail-end device for tunnel-te1 192.168.0.7
Answer: C
NEW QUESTION 70
Refer to the exhibit.
While configuring router 2 with all the default values, a network engineer cannot see any route received in router 1. How should the engineer solve the issue?
- A. Set the network type in S1/0 to point-to-point.
- B. Modify the IP address or mask of the interface to a valid one.
- C. Modify the router ID to be the interface IP on the serial.
- D. Set up a priority different than 0 in the interface.
Answer: B
NEW QUESTION 71 
Refer to the exhibit. A network operator is working to filter routes from being advertised that are covered under an aggregate announcement. The receiving router of the aggregate announcement block is still getting some of the more specific routes plus the aggregate. Which configuration change ensures that only the aggregate is announced now and in the future if other networks are to be added?
- A. Set each specific route in the AGGRO policy to drop instead of suppress-route
- B. Set each specific route in the AGGRO policy to remove instead of suppress-route
- C. Filter the routes on the receiving router
- D. Configure the summary-only keyword on the aggregate command
Answer: D
NEW QUESTION 72
Refer to the exhibit.
A network engineer implemented this segment routing configuration. Which statement about the output is true?
- A. The default segment routing global block range is being used on this device.
- B. The device must be reloaded for these ranges to be allocated and used.
- C. This range conflicts with the segment routing local block range.
- D. A nondefault segment routing global block range is being used on this device.
Answer: D
Explanation:
Reference:
segment-routing-book/seg-routing-global-block.html
NEW QUESTION 73 
Refer to the exhibit. CE1 is the gateway router into the provider network via PE1. A network operator must inject a default route into OSPF area 0. All devices inside area 0 must be able to reach PE1. Which configuration achieves this goal?
- A.
- B.
- C.
- D.
Answer: A
Explanation:
Explanation/Reference: https://www.cisco.com/c/en/us/support/docs/ip/open-shortest-path-first-ospf/47868-ospfdb9.html
NEW QUESTION 74
......
Topics of Implementing Cisco Service Provider Advanced Routing Solutions (300-510 SPRI) Exam
These core topics of 310-510 SPRI practice test listed below are general recommendations for the material that is likely to be used for the examination. However, on any delivery of the test, other similar topics could also appear. The guidelines below can update at any time without notice to better represent the contents of the 310-510 SPRI exam dumps pdf and for clarity purposes.
It is recommended that, where possible, the applicant use these courses and/or other resources to provide background information on the exam objectives. The syllabus for the Implementing Cisco Service Provider Advanced Routing Solutions (300-510 SPRI) examination is listed below in detail for each section of 300-510 SPRI exam dumps:
- Implement BGP Security Options
- Implementing and Verifying Open Shortest Path First Multiarea Networks
- Implement Tunnels for IPv6
- Implement Cisco MPLS TE
- Implement enhanced Protocol-Independent Multicast - Sparse Mode (PIM-SM) features
- Implementing Interdomain IP Multicast
- Securing BGP in Service Provider Networks
- Describe how traffic engineering is used in segment routing networks
- Troubleshoot Routing Protocols
- Implement MPLS in the Service Provider Core
- Implementing Segment Routing
- Troubleshoot OSPF, ISIS, and BGP
- Implement and verify segment routing technology within an interior gateway protocol
- Describing Segment Routing Traffic Engineering (SR-TE)
- Implement mechanisms for dynamic Rendezvous Point (RP) distribution
- Scaling BGP in Service Provider Networks
- Implementing and Verifying MPLS
- Improving BGP Convergence and Implementing Advanced Operations
- Implementing PIM-SM Enhancements
- Implement BGP Route Reflectors
- Implement Multiarea IS-IS
- Implementing Distributed Rendezvous Point Solution in Multicast Network
- Implementing Route Redistribution
- Implement and verify MPLS
- Troubleshooting Routing Protocols
- Implement and troubleshoot MPLS traffic engineering
- Implement BGP security options
- Implementing Cisco MPLS Traffic Engineering
- Implementing IP Multicast Concepts and Technologies
Cisco 300-510 Pre-Exam Practice Tests | CertkingdomPDF: https://www.certkingdompdf.com/300-510-latest-certkingdom-dumps.html
300-510 practice test questions, answers, explanations: https://drive.google.com/open?id=1FhEZaJB9aD7qxGxnCSU8RbwMO1uYJp3f